Bihar

Home server, the primary host for the hives, and the KubeStellar hub. Since 2026-11-17 it runs Bluefin, not Talos. The Talos page is archived.

HardwareASRock B660M-STX, Intel, 24 threads, 62 GB of RAM
Disk1.9 TB NVMe (/var)
OSBluefin ghcr.io/projectbluefin/utah:testing (bootc: read-only /usr, writable /etc and /var)
NetworkWiFi (wlp3s0). Not on the same LAN as karnataka.
Tailnetbihar / 100.103.44.48 (bihar.manatee-basking.ts.net)
Accessssh james@bihar (passwordless sudo through /etc/sudoers.d/zz-james)
AnsibleYes: host_vars/bihar.yml, skip_pipewire_audio: true

Roles

  1. Active hive host. The hive containers (hub, hub-front, school and reef) run under rootful podman compose, and spindle's Caddy sends public traffic to them. See Hives hosting and failover.
  2. k3s and KubeStellar hub. A single-node k3s runs KubeStellar 0.30.2, with ITS its1 and WDS wds1. bihar and karnataka are both workload clusters. See Home k3s and KubeStellar.

Host settings (applied 2026-11-17)

  • No sleep: the sleep, suspend and hibernate targets are masked, the 90-nosleep.conf drop-ins are in /etc/systemd/{sleep,logind}.conf.d/, and the GDM dconf sleep-inactive-ac-type='nothing' is set. Before this change, GNOME suspended the host after 15 min idle, and the host went offline.
  • Default target is multi-user.target: no graphical login. Use systemctl isolate graphical.target to start one.
  • Wake-on-LAN is set to magic on enp0s31f6. The host uses WiFi, so wake-on-LAN works only if you connect a cable.
  • To do: in the firmware, set "Restore on AC/Power Loss" to Power On. This setting is necessary because the hives depend on this host.
  • Dotfiles bootstrap fixes for a new bootc host are in hanthor/dotfiles#385.
  • Bitwarden phase 2 is not done yet. Run just apply -e skip_pipewire_audio=true from an interactive terminal.

Timers

UnitPurpose
hive-reconcile.timerFollows the hive lease on spindle (every 1 min)
hive-sync.timerPushes the hive data to karnataka while bihar is active (every 15 min)
fleet-osquery-report.timerFleet facts
tailscale-cert-renew.timerTailscale TLS certificate

Gotchas

  • Do not use pkill -f <pattern> over SSH if the pattern also occurs in the SSH command line. The command stops your own session.
  • gsettings over SSH needs DBUS_SESSION_BUS_ADDRESS=unix:path=/run/user/1000/bus.
  • semanage cannot write on bootc. Use chcon for SELinux labels.